Compaq 5700 - Manual (Page 7)

User’s Guide 5
■ Do not plug a modem or telephone cable into the Network Interface
Card (NIC) receptacle.
■ Disconnect the modem cable before opening a product enclosure,
touching or installing internal components, or touching an
uninsulated modem cable or jack.
■ Do not use a telephone line to report a gas leak while you are in the
vicinity of the leak.
Precautions for Products with Laser Devices
In addition to the general precautions described earlier in this section, be
sure to observe the following precautions when operating a product
equipped with a laser device. Failure to observe these precautions could
result in fire, bodily injury, and damage to the equipment.
■ Do not operate controls, make adjustments, or perform procedures
to a laser device other than those specified herein or in the
CD-ROM drive installation guide.
■ Allow only Compaq-authorized service technicians to repair the
laser equipment.
■ All Compaq systems equipped with CD-ROM drives comply with
appropriate safety standard including IEC 825. With specific regard
to the laser, the equipment complies with laser product performance
standards set by government agencies as a Class 1 laser product. It
does not emit hazardous light; the beam is totally enclosed during
all modes of customer operation and maintenance.
This system is classified as a CLASS 1
LASER PRODUCT. This label is
located on the outside of your system. A
similar label also appears on the internal
CD-ROM installed in your system.
306852-001.book Page 5 Wednesday, July 31, 2002 5:16 PM