Desa Tech FIREBOX CGFB32CC - Manual (Page 11)

www.fmiproducts.com 124970-01A 11
6. If using an optional perimeter trim kit,
install the trim after final finishing and/or
painting of wall. See instructions included
with trim accessory for attaching trim.
7. Install and properly test gas log heater.
Follow installation instructions included
with the vent-free gas log heater that is
being installed.
IMPORTANT: When finishing your firebox,
combustible materials such as wall board,
gypsum board, sheet rock, drywall, plywood,
etc. may be butted up next to the sides and top
of the firebox. Combustible materials should
never overlap the firebox front facing.
WARNING: do not allow any
combustible materials to overlap
the firebox front facing.
IMPORTANT: Noncombustible materials such
as brick, tile, etc. may overlap the front facing,
but should never cover any necessary open-
ings like louvered slots.
WARNING: do not allow
noncombustible materials to
cover any necessary openings
like louvered slots.
WARNING: use only non-
combustible mortar or adhe-
sives when overlapping the front
facing with noncombustible
facing material.
INSTALLATION
Continued
Figure 7 - Attaching Firebox to Wall Studs
Nailing
Flanges
Nails or Wood
Screws
INstAllING FIRebox usING
optIoNAl AccessoRy mANtels
warninG: a qualified ser-
vice person must install firebox.
follow all local codes.
This firebox may be installed using a cabinet
mantel accessory against a wall in your
home. The firebox and cabinet mantel can
be installed directly on the floor. A trim kit is
included with the mantel accessories. Follow
instructions with mantel for installation.
INstAllING GAs lINe
notiCe: a qualified service per-
son must connect heater to gas
supply. follow all local codes.
IMPORTANT: See Connecting to Gas Supply
in your log set owner’s manual for details on
gas hookup.
You may run the gas line from either side of
the firebox (see Figure 8). Decide which side
you want to run the gas line from.
Note: This is one option for installing shutoff
valve. Check local codes for equipment shut-
off valve location requirements.
Figure 8 - Installing Gas Line and
Equipment Shutoff Valve (Model May
Vary From Illustration)
Knockout
Locations
(Knock Out
One Hole)
Gas Line Hole
Equipment Shutoff
Valves (Install One)