Craftsman 572.6112 - Manual (Page 15)

15
MAINTENANCE (CONTINUED)
4. Install existing or new brushes so the
curved surface of the brush end
matches the curvature of the motor
commutator (as seen through the brush
opening).
NOTE: The detent on the brass clip must fit
into the slot on the side of the brush pocket,
which secures the brass clip in the proper
position (Figure C).
5. Reinstall brush covers by angling the
non-clip end into the opening. Make
certain brush spring is centered in the
“V” notch on brush, then snap closed
the clip end of the brush cover.
6. Plug power cord into a wall outlet. Run
the rotary tool at full speed for 5
minutes under no load. This will
properly seat the brushes and extend
the life of the tool.
Tool Lubrication
There is no need to lubricate the rotary tool.
Cleaning The Tool
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
The tool may be cleaned
with compressed air.
Always wear safety goggles
when cleaning tool with
compressed air.
Certain cleaning agents
and solvents will damage
plastic parts. Some of these are:
gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia
and household detergents that contain
ammonia.
Clean the “soft grip” areas of the tool using a
damp cloth. Tougher soiled areas may
require more than one wipe application to
get clean.
CAUTION
!