Vehicle seat belts continued – Century PM-1026AB User Manual

Page 36

Text mode
Original mode

VEHICLE SEAT BELTS continued

Pull on latch plate (fig. a). If belt slides freely
through latch plate, a locking clip MUST
be used (see Locking Clip section).

Some combination lap/shoulder belts with
sliding latch plates may be converted into an
“automatic locking mode” that will allow use
without a locking clip. See vehicle owner’s
manual and label on vehicle belts for
instructions.

(fig. a)

❃

Combination Lap/Shoulder Belt
with Sliding Latch Plate

(fig. b)

❃

Combination Lap/Shoulder Belt
with Locking Latch Plate

The locking latch plate on some seat belts may
slip and loosen after being buckled on car seat if
positioned at a certain angle. If this happens,
flip the latch plate over (fig. b) and re-buckle.
Test installation again to see if this works. If
not, move car seat to another seating position.

Pull

Flip