Desa Tech CGF265NVA - Manual (Page 12)

12
102664
INSTALLING
Continued
2. Break off nailing flanges (see Figure 8) with hammer or pliers.
3. Place mantel and base in desired location. Place heater in front opening of
mantel. Make sure all pieces fit properly. Remove mantel.
4. Mark floor and base or wall for gas line entrance. Make sure there is enough
clearance between heater and mantel for gas line. IMPORTANT: Make sure
there are no electrical lines where gas piping will go through floor or wall.
5. Cut an access hole in hearth base top to run flexible gas line to fireplace (see
Figure 9). Make sure to locate access hole so cabinet mantel will cover it when
installed.
Note: You can secure base to floor using wood screws. Countersink
screw heads and putty over.
Figure 9 - Placing Hearth Base Accessory Against Wall
Electrical Outlet
Hearth Base
Flexible Gas Line
Gas Line Access
Hole
6. Install gas piping to fireplace location. This installation includes an approved
flexible gas line (if allowed by local codes) after the manual shutoff valve. The
flexible gas line must be the last item installed on the gas piping. See Installing
Gas Piping to Fireplace Location, page 16.
Nailing Flanges
Figure 8 - Location of Nailing Flanges