Chicago Electric 94533 User Manual

Page 2

SKU 94533

For technical questions, please call 1-800-444-3353

PAGE 2

OPERATING INSTRUCTIONS

To Charge A Battery Using The Battery Clamps:

NOTE: See the last page of this instruction sheet for a complete Parts List and
Assembly Diagram.

Make sure the transmission of the vehicle is in

“PARK” and the emergency brake

has been set. Also, turn off the engine of the vehicle prior to connecting the Battery
Charger to the battery of the vehicle.
Attach the

RED/POSITIVE (+) Battery Clamp of the Temporary Connection Cord (8)

to the

POSITIVE battery terminal of the vehicle.

Attach the

BLACK/NEGATIVE (–) Battery Clamp of the Temporary Connection Cord

(8) to the

NEGATIVE battery terminal of the vehicle.

Connect the Temporary Connection Cord (8) to the Output Cord (3) of the Battery
Charger.
Plug the Power Cord (2) of the Battery Charger into the nearest 120 volt, grounded,
electrical outlet.
The

RED (AC Power) light on the Main Unit (1) of the Battery Charger should be

illuminated. This light indicates the Main Unit is receiving 120 volt electrical power
from the electrical outlet.
The

YELLOW (Charging) light on the Main Unit (1) of the Battery Charger should

be illuminated. This light indicates charging is taking place.
The

GREEN (Charged) light on the Main Unit (1) of the Battery Charger will illuminate

when the vehicles’ battery is fully charged.
Once the vehicle’s battery is fully charged, unplug the Power Cord (2) from its 120 volt
electrical outlet. Disconnect the

RED/POSITIVE (+) Battery Clamp of the Temporary

Connection Cord (8) from the

POSITIVE battery terminal of the vehicle’s battery.

Then disconnect the

BLACK/NEGATIVE (–) Battery Clamp from the Temporary

Connection Cord (8) from the

NEGATIVE battery terminal of the vehicle’s battery.

Make sure to store all parts of the Battery Charger in a clean, dry, safe location out
of reach of children.

10.