Cabletron Systems E1100 - Manual (Page 22)

Page 2-12
INSTALLATION
1
2
1. Backplate
2. Thumbscrew
Figure 2-10. Micro Channel Backplate Detail
CAUTION: The adapter is sensitive to static discharges. Hold it by the
corners. Avoid contact with the PC bus edge connector or any of the
components. Failure to observe all static precautions may result in
damage to the adapter.
• If you have not already done so, carefully remove the
adapter from its protective pouch, and visually inspect it.
• Remove the protective backplate (1, Fig. 2-10) from the
selected slot, as shown in Figure 2-10. Loosen the
thumbscrew (2) holding the backplate (1) in place over the
selected slot, and slide the backplate out of the slot.
• Orient the adapter (2, Figure 2-11) so the PC edge bus
connector (3) is pointed down and the ports face out the
back of the PC as shown in Figure 2-11.