Creek Audio CD50 - Manual (Page 4)

4
CD53 & CD50 Compact Disc Player
CCA AUUTTIIO ON N
Before connecting or disconnecting a unit from your
audio system, make sure that you switch off the
power to each component.
Ensure that you make the correct connections,
paying attention to the L (left channel) and R (right
channel) marks. Plug in the cable securely. Loose
connections will result in unsatisfactory sound
reproduction or noise problems.
If this unit interferes with the tuner, switch it off
during tuner operation.
1. LINE OUT SOCKETS
Connect one end of the interconnect cable to the
unit's AUDIO OUTPUT sockets and the other end to
the sockets labelled CD or AUX, or to other line
inputs on the amplifier.
Do not connect it to the amplifier's PHONO input if a
phono circuit is installed.
2. DIGITAL OUTPUT
This output enables you to connect the CD player to
a stand-alone D to A converter in order to change
the signal into a stereo analogue one. The digital
output can be accessed via the co-axial SPDIF
socket on the rear panel.
3. AC POWER SOCKET, IEC TYPE
220V-240 V AC or 110V-120 V AC
4. AC POWER CORD
After completing the installation and all connections,
make sure that the POWER switch on the back
panel of the unit is set to OFF (O).
Then plug the power cord into a live AC outlet.
CONNECTING THE COMPACT DISC PLAYER
WARNING
UNAUTHORISED RECORDING OF COPYRIGHT MATERIAL MAY VIOLATE APPLICABLE COPYRIGHT LAWS.
THE DISTRIBUTOR ASSUMES NO RESPONSIBILITY FOR THE UNAUTHORISED DUPLICATION, USE OR
OTHER ACTS, WHICH INFRINGE UPON THE RIGHTS OF COPYRIGHT OWNERS.
Integrated stereo amplifier
Un-balanced
Audio Output
Digital Output
Optical and
Co-Ax
A C Mains
Input
CD53 and CD50 CD Player
A C Mains
Fuse
Power
on/off
switch I / 0
Balanced
Audio Output
CD53 only