AAXA Technologies P3 - Manual (Page 7)

Getting Started
1. Connect the power cord to the P3.
2. Connect the wall plug into the wall power source.
3. Press POWER button and hold for 2-3 seconds to switch on or switch off
the power.
4. The projector will boot with a boot screen and finish booting to the media
player’s Main Menu.
5. If the projector does not boot to the “Main Menu” Press “SRC”, select “Me-
dia” to start the Media Player
• 4 hours of charge time is required to reach a full charge.
• When charging, the inside of the P3 will glow red.
• When fully charged, the inside of the P3 will turn blue.
5
Powering ON the projector
Chapter 2
Powering OFF the projector
1. Press and hold the power button for 3 seconds.
2. The optical engine should power off and the fan should stop spinning.
Note: The P3 Projector battery does not charge when it is in operation.