Cobra Electronics XRS 9965/70G - Manual (Page 8)

English 10
Getting Started
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Nothing Comes Close to a Cobra ® 11
Getting Started
Your Detector
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Display Control
•
Illumination
The display illumination intensity can be adjusted to suit driving conditions:
Bright for daytime driving.
Dim for dusk driving.
Dimmer for night driving.
The Dark icon will remain to indicate the detector is On. (The Dark Icon
will be replaced by a blinking dot, if the display is not set for Always On.)
You can adjust the screen illumination
by Clicking the Brightness icon to step
through the levels in the sequence
listed above.
Standby Screens
•
Main Standby Screen
Displays the maximum possible information about the detector
and its settings. The GPS and Compass icons will show only if
the GPS Locator unit is connected. From this screen you can
select modes and alternative standby screens, control unit
functions and access setup menus.
Compass
The compass indicates driving direction if the GPS Locator
unit is installed and receiving a signal. If the GPS signal is
lost, the GPS icon will change to that status and the center of
the Compass icon will show two bars. To display this standby
screen, click on the Compass icon in the Main Standby screen.
Speed
If the GPS Locator unit is installed and receiving a signal, the
vehicle’s speed will be shown. See page 39 for Speed Alert and
Speed Units information. To display this standby screen, click
on the Compass icon in the Compass screen.
Compass and Speed
Combines Compass and Speed information in a single screen.
To display this standby screen, click on the Speed icon in the
Speed screen. From this screen, clicking on the Compass or
Speed icons will return the unit to the Main Standby screen.
Lat/Lon
If the GPS Locator unit is installed and receiving a signal,
the vehicle’s present location will be shown and continuously
updated. To display this standby screen, press the GPS icon in
any standby screen. Pressing the Exit icon in this screen will
return the unit to the last Standby screen.
Brightness Icon
NOTE
Pressing the
Brightness icon provides a shortcut to the Display
Color (see page 23) and Display Timer (see page 23) settings in
the User Settings menu.
NOTE GPS Icon, Compass, Speed and Lat/Lon only appear when used in conjunction
with GPS Locator (included with XRS 9970G; optional for XRS 9965).