Ultrasecure coded programming mode – CLIFFORD concept 50 User Manual
Page 18
UltraSecure Coded Programming Mode
Your Concept 50 vehicle security system allows you to set many of its features to
your own personal preferences. We have made the programming procedures very
simple: to make a change, you just press the PlainView switch a few times. The
system comes from the factory with all of its features pre-programmed as noted in
the table that follows. To change any of the settings, use the procedure noted. To
restore the feature to its factory setting, just repeat the procedure.
How to program user-selectable features
1. Select the feature you wish to program from the table that follows. Note the
number of momentary taps.
2. Turn your vehicle’s ignition switch to its “ON” position.
3. Enter your valet code (see page 10).
4. When the LED turns on, immediately tap and release the momentary side of the
switch the number of times indicated in the third column of the programming
table for the feature you selected (after the first three taps, you will hear a single
chirp confirmation each time you tap the momentary side).
a. If noted, perform the “secondary action.”
5. Return the switch to its centre position. You will hear 1 chirp and the LED will
turn off. Turn the ignition off.
6. Repeat steps 1-5 for any other features you wish to program.
Programming table for user-selectable features
Feature
Factory
setting
# of
momentary
taps
Secondary
action
Program
completion
confirmation
Result
Lock upon
AutoArming
OFF
4
—
1 chirp 3
seconds after
last step
Change state from
OFF to ON or vice-versa
Arm/Disarm
Chirp
Confirmation
ON
5
—
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Valet Code
See Setting your own secret valet code on page 11.
+
AutoLock/
AutoUnLock
ON
7
—
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
Siren
Duration
30 sec.
8
—
1 chirp 3
seconds after
last step
Change duration from 30 to
60 seconds or vice-versa
FACT
ON
9
—
1 chirp 3
seconds after
last step
Change state from
ON to OFF or vice-versa
16