beautypg.com

Programming a non-rolling code, Reprogramming a single homelink® button – Dodge 2013 Charger-SRT - Owner Manual User Manual

Page 286

background image

Programming A Non-Rolling Code

For programming Garage Door Openers manufactured
before 1995.

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)

away from the HomeLink® button you wish to pro-
gram while keeping the HomeLink® indicator light
in view.

3. Simultaneously press and hold both the Homelink®

button you want to program and the hand-held trans-
mitter button.

4. Continue to hold both buttons and observe the indi-

cator light. The Homelink® indicator will flash slowly
and then rapidly after HomeLink® has received the
frequency signal from the hand-held transmitter. Re-
lease both buttons after the indicator light changes
from slow to rapid.

5. Press and hold the programmed HomeLink® button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should
activate when the HomeLink® button is pressed.

• To program the two remaining HomeLink® buttons,

repeat each step for each remaining button. DO NOT
erase the channels.

Reprogramming A Single HomeLink® Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Cycle the ignition to the ON/RUN position.

2. Press and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do
not release the button.

284

UNDERSTANDING THE FEATURES OF YOUR VEHICLE