Dodge 2011 Nitro - User Guide - Manual (Page 44)

UNIVERSAL GARAGE DOOR OPENER
(HomeLink
®
)
Programming HomeLink ®
Begin Programming
• The HomeLink ® buttons are located in
the sun visor.
• Erase all channels before you begin
programming by holding the two
outside buttons for up to 20 seconds
until the red indicator flashes.
• Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN
position.
• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink ® buttons
while keeping the indicator light in view.
• Simultaneously, press and hold both the chosen HomeLink ® button and the
hand-held transmitter button until the HomeLink ® indicator flash rate changes
from a slow to a rapidly blinking light, then release both the HomeLink ® and the
hand-held transmitter buttons. This may take up to 30 seconds, or longer in rare
cases.
• Press and hold the just-programmed HomeLink ® button; if the indicator light stays
on constantly, programming is complete and the garage door should open.
NOTE:
• Only use this transceiver with a garage door opener that has a “stop and reverse”
feature as required by Federal safety standards. This includes most garage door
opener models manufactured after 1982. Do not use a garage door opener without
these safety features. Call toll-free 1–800–355–3515 or, on the Internet, at
www.HomeLink.com for safety information or assistance.
• If you are having difficulty programming your HomeLink ® and your garage door
opener was manufactured after 1995, you may have a rolling code. Follow the steps
below for Programming A Rolling Code System.
ELECTRONICS
42