beautypg.com

Uconnect™ voice command, Voice command for text messaging, Changing the volume – Dodge 2011 Dakota User Manual

Page 29: Electronics, Warning

background image

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a

comfortable level while the Uconnect™ system is speaking. Please note the
volume setting for Uconnect™ is different than the audio system.

NOTE: To access the tutorial, press the Uconnect™ hard-key. After the BEEP, say
“tutorial”. Press any hard-key/button or touch the display (Touch-Screen radio) to
cancel the tutorial.

WARNING!

• Any voice commanded system should be used only in safe driving

conditions following local laws and phone use. All attention should be
kept on the roadway ahead. Failure to do so may result in a collision
causing you and others to be severely injured or killed.

• In an emergency, to use Uconnect™ Phone, your mobile phone must be:

• turned on,
• paired to Uconnect™ Phone,
• and have network coverage.

Uconnect™ VOICE COMMAND

• The Uconnect™ Voice Command system allows you to control your AM, FM

radio, satellite radio, disc player, HDD, Uconnect™ Phone, a memo recorder,
and supported portable media devices.

• When you press the Voice Command button

located on the radio

faceplate or steering wheel, you will hear a beep. The beep is your signal to
give a command. If you do not say a command within a few seconds, the
system will present you with a list of options. If you ever wish to interrupt the
system while it lists options, press the Voice Command button

, listen

for the BEEP, and say your command.

Voice Command for Text Messaging

• If equipped with Uconnect™ Voice Command, your Media Center 430N radio

may be able to play incoming SMS messages through the vehicle sound
system.

• It also allows you to respond by selecting from various pre-defined phrases.

• Not all phones are compatible with this feature. Refer to the phone

compatibility list at www.ramtrucks.com/uconnect. Connected mobile phones
must be bluetooth-compatible, and paired with your radio.

Changing The Volume

• Start a dialogue by pressing the Voice Command button

, then say a

command (for example, “tutorial”).

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a

comfortable level while the Voice Command system is speaking. The volume
setting for Voice Command is different than the audio system.

ELECTRONICS

27