Dodge 2011 Charger - User Guide - Manual (Page 16)

• Child seats with flexible or fixed rigid attachments can be installed in all rear
seating positions. Child seats can be installed using the LATCH system in either or
both outboard seating positions or the center position, but not all three at the
same time. If a child seat is installed in an outboard seating position using the
lower anchors, then the vehicle seatbelt must be used for the center position.
• Never install LATCH-compatible child seats such that two seats share a common
lower anchorage.
• The rear seat lower anchorages are round bars, located at the rear of the seat
cushion where it meets the seatback. The rear seat lower anchors can be readily
identified by the symbol
located on the seatback directly above the
anchorages and are just visible when you lean into the rear seat to install the child
restraint.
• In addition, there are tether strap anchorages behind each rear seating position
located in the panel between the rear seatback and the rear window. These tether
strap anchorages are under a plastic cover.
• Loosen the child seat adjusters on the
lower straps and tether straps so that
you can attach the hook or connector
to the lower and tether anchorages
more easily.
• Attach the lower hooks or connectors
over the top of the seat cover material.
• Then rotate the tether anchorage cover directly behind the seat where you are
placing the child restrain and attach the tether strap to the anchorage, being
careful to route the tether strap to provide the most direct path between the anchor
and the child restrain.
• Tighten all three straps as you push the
child restraint rearward and downward
into the seat.
• For center seating position route the
tether strap over the seatback and
adjustable headrest (with the headrest
in the full down position) then attach
the hook to the tether anchor located
in the panel between the rear seatback
and the rear window.
GETTING STARTED
14