beautypg.com

Using homelinkĥ, Reprogramming a single homelinkĥ button, Security – Dodge 2010 Challenger - Owner Manual User Manual

Page 149: Troubleshooting tips, Using homelink, Reprogramming a single homelink, Button

background image

Then proceed with Step 4 under “Programming
HomeLink

௡” earlier in this section.

Using HomeLink

To operate, press and release the programmed
HomeLink

௡ button. Activation will now occur for the

trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.

Reprogramming A Single HomeLink

Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Place the ignition in the RUN position.

2. Press and hold the desired HomeLink

௡ button for

20 seconds until the EVIC display states “CHANNEL #
TRAINING.” Do not release the button.

3. Without releasing the button, proceed with Program-
ming HomeLink

௡ Step 2 and follow all remaining steps.

Security

It is advised to erase all channels before you sell or turn
in your vehicle.

To do this, press and hold the two outside buttons for
20 seconds until the EVIC message states “CHANNELS
CLEARED.” Note that all channels will be erased. Indi-
vidual channels cannot be erased.

The HomeLink

௡ Universal Transceiver is disabled when

the Vehicle Security Alarm is active.

Troubleshooting Tips

If you are having trouble programming HomeLink

௡, here

are some of the most common solutions:

• Replace the battery in the original transmitter.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

147

This manual is related to the following products: