Dodge 2009 Journey - Quick Reference Guide - Manual (Page 4)

SPeed ConTrol lever
CRUisE ON/OFF
• Push the ON/OFF button to activate the Speed Control.
• CRUISE will appear on the instrument cluster to indicate the
speed Control is on.
• Push the ON/OFF button a second time to turn the system off.
sET
• With Speed Control on, press down and release the lever to set a
desired speed.
aCCEL/DECEL
• Press and hold the lever up to accelerate or down to decelerate the
vehicle; release the lever to save the new set speed.
• Once a speed is set, tapping the lever up or down will increase or
decrease the set speed approximately 1 mph (2 km/h).
CaNCEL
• Pull the lever toward you, or apply the brakes to cancel the set speed
and maintain the set speed memory.
• Press the ON/OFF button to turn the system off and erase the set
speed memory.
REsUME
• To resume a previously selected set speed in memory, push the
lever up and release.
Push on/oFF
Button
wiPerS
iNTERMiTTENT, LOW, aND HiGH OPERaTiON
• Rotate the end of the lever to the first detent position for one of five
intermittent settings, the second detent for low wiper operation and
the third detent for high wiper operation.
MisT
• Pull down on the lever and release when a single wipe is desired.
WasHER OPERaTiON
• Pull the lever towards you and hold for as long as spray is desired.
REaR WiPER OPERaTiON
• Rotate the center portion of the lever forward to the first detent for
rear wiper operation.
REaR WasHER OPERaTiON
• Rotate the center portion of the lever past the first detent to activate
the rear washer.
eviC ConTrolS
• The EVIC features a driver interactive display that is located in the
instrument cluster. Pressing the controls on the steering wheel allows
the driver to select vehicle information and Personal settings. Refer to
Owner’s Manual for further details.
Front Washer
(pull toward driver)
Front Wipers rear Wiper/Washer
mist (down)