Dodge 2009 Durango - Quick Reference Guide - Manual (Page 10)

spEEd control
CRUisE ON/OFF
• Push the ON/OFF switch to activate the Speed Control.
• CRUISE will appear in the instrument cluster to indicate the
speed Control is on.
• Push the ON/OFF switch a second time to turn the system off.
sET
• With the Speed Control on, at a desired speed greater than 25 mph
(40 km/h), push and release the set switch.
ACCEL/DECEL
• Push and hold the Resume/Accel switch to accelerate or push and
hold the Decel switch to decelerate the vehicle; release the switch to
save the new set speed.
• Once a speed is set, pushing the Resume/Accel switch once or Decel
switch once will increase or decrease the set speed approximately
1 mph (2 km/h).
CANCEL
• Push the Cancel switch, or apply the brakes to cancel the set speed
and maintain the set speed memory.
• Push the ON/OFF switch to turn the system off and erase the set
speed memory.
REsUME
• To resume a previously selected set speed in memory, push the
Resume/Accel switch and release.
Push
on/oFF
Push set
Push
resume/accel
Push
Cancel
Push
Decel
175472_09a_Durango_QRG.indd 11 10/23/08 1:03:43 PM