Hella Jumbo 320 FF Halogen Driving - Manual (Page 9)

9
According to circuit diagram II the
auxiliary lamps can be switched on
in addition to the main beams with a
separate switch.
According to circuit diagram III the
position lamps are wired up and
switched on together with the
parking light.
Disconnect earth lead (-) from
battery for safety.
Lay and connect wires according to
circuit diagram.
According to circuit diagram I the
auxiliary lamps are switched on
together with the existing main
beams.
Install relay with connection
terminals pointing downwards so
that they are protected against
splashing water.
If required, and legally permissible,
install switch in dashboard.
Page 4: Electrical connection
Reconnect earth lead (-) to battery.
Check lights, tighten connection
wires securely.
Page 5: Accessories
Have the driving lamps adjusted
at a workshop or service station.
Only properly adjusted lamps
provide optimum illumination. The use of the enclosed protective
caps (enclosed where applicable)
is not permissible in areas
governed by German Traffic Laws.
(not included with kit)
1. Bulb for H7 main beam
2. Bulb for position light
3. Switch
4. Cable with relay
5. Relay
6. Two-point mount
7. Protecting cap
One more tip:
Keep the lenses clean. Dirt can
absorb up to 80% of the light.
You drive more safely when you
can see and be seen well. Do
you have spare bulbs and fuses
in your vehicle?
If you have any questions or
installation problems: Contact
your Hella stockist.