Gamo LLCP Laser and Light with Scope Mount User Manual

Page 5

E.) POSITIONING THE REMOTE SWITCHES
1. Once you have decided the location of the switches on the rifle stock, place adhesive side
of velcro strip on the stock of the rifle by pressing the adhesive portion against the stock.
2. Attach the other adhesive portion to the back of the pressure sensitive switches by
pressing the adhesive side of the surface of the Velcro strip against them.
3. Secure the pressure sensitive switches to the stock by pressing both parts of the
Velcro together.

F.) ZEROING THE LASER SIGHT

First, the laser needs to be aligned with the path of the pellet/bullet to do this follow the steps

described below.

1) Activate the laser by pressing the switch.

2) From a bench rest position, fire three shots at the

center of the target.

3) Observe were the pellets or bullets strike the

target. Keeping the laser dot pointing at the

center of the target and using the windage and

elevation adjustments screws located in the laser

body, move the laser dot to the center of the

group formed by the three shots previously fired.

Fire three more shots and note the points of

impact on the target. Make additional adjustment

of the laser as necessary.

G.) ADJUSTING THE LASER WINDAGE AND ELEVATION.

1) The elevation adjustment screw is located on top of the laser. When the screw is turned

counterclockwise, the Laser dot will move “Up” and when is turned clockwise the laser dot

will move “Down”.

2) The windage adjustment screw is located at 45° angle on the right side of the laser body.

When turned counter-clockwise, the laser dot will move to the “Right”. When turned clockwise

the laser dot will move to the “Left”.

3) To align the laser dot with the center of the cross-hairs of the reticle, move it by turning the

windage and elevation screws on the laser.