NISSAN 2013 Sentra - Owner's Manual User Manual

Page 202

● Do not force the iPod® cable into the

USB port. Inserting the USB device
tilted or up-side-down into the port may
damage the iPod® cable and the port.
Make sure that the iPod® cable is con-
nected correctly into the USB port.
(Some iPod® cables come with a
mark as a guide. Make sure that the
mark is facing the correct direction be-
fore inserting the iPod® cable.)

● Do not locate objects near the iPod®

cable to prevent the objects from lean-
ing on the iPod® cable and the port.
Pressure from the objects may damage
the iPod® cable and the port.

To connect an iPod® to the vehicle so that the
iPod® can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console

᭺

. Connect the

iPod®-specific end of the cable to the iPod®
and the USB end of the cable to the USB jack on
the vehicle. If your iPod® supports charging via a
USB connection, its battery will be charged while
connected to the vehicle with the ignition switch
in the ACC or ON position.

While connected to the vehicle, the iPod® can
only be o perated by the vehicle audio controls.

To disconnect the iPod® from the vehicle, re-
move the USB end of the cable from the USB
jack on the vehicle, then remove the cable from
the iPod®.

* iPod® is a trademark of Apple Inc., registered in
the U.S. and other countries.

Compatibility

The following models are available:

● Fifth generation iPod® (Firmware version

1.2.1 or later)

● First generation iPod Classic® (Firmware

version 1.1 or later)

● Second generation iPod Classic® (Firm-

ware version 2.0.3 or later)

● First generation iPod touch® (Firmware ver-

sion 2.1.0 or later)

● Second and third generation iPod touch®

(Firmware version 3.1.2 or later)

● First generation iPod nano® (Firmware ver-

sion 1.3.1 or later)

● Second generation iPod nano® (Firmware

version 1.1.3 or later)

● Third generation iPod nano® (Firmware ver-

sion 1.0.2 or later)

● Fourth generation iPod nano® (Firmware

version 1.0.4 or later)

● Fifth generation iPod nano® (Firmware ver-

sion 1.0.1 or later)

The iPod touch® may not respond quickly with
the system in some cases.

Make sure that the iPod® firmware is updated.

Audio main operation

Place the ignition switch to the ACC or ON
position. Then, press the CD·AUX or iPod®
MENU button repeatedly to switch to the iPod®
mode.

If the audio system is turned off while the iPod® is
playing, the iPod® plays when the audio system
is turned back on.

If the audio system is off, pressing the CD·AUX or
iPod® MENU button turns the audio system on
and plays the iPod®.

If the audio system is on, the audio system auto-
matically begins playing tracks from the iPod®
when it is plugged into the jack.

iPod® MENU button:

Press the iPod® MENU button while the iPod®
is connected to show the iPod® operation menu
on the audio display. Scroll through the menu list
using the TUNE·SCROLL control dial. Press EN-

Monitor, climate, audio, phone and voice recognition systems

4-55