Cruise control, Interface – NISSAN 2014 Rogue - Quick Reference Guide User Manual

Page 19

To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

CRUISE CONTROL

The cruise control system enables you to set a constant

cruising speed once the vehicle has reached 25 mph
(40 km/h). The system will automatically maintain the
set speed until you tap the brake pedal, accelerate,
cancel or turn the system off.

To activate the cruise control, push the ON•OFF

switch

. The CRUISE indicator light in the

instrument panel will illuminate.

To set cruising speed, accelerate the vehicle to the

desired speed, push the COAST/SET switch

and release. The SET indicator light

in the instrument panel will illuminate and the set speed will display next to the indicator
light. Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

To reset at a faster cruising speed, push and hold the ACCEL/RES switch

When the vehicle attains the desired speed, release the switch.

To reset at a slower cruising speed, push and hold the COAST/SET switch

Release the switch when the vehicle slows to the desired speed.

To cancel the preset speed, tap the brake pedal or push the CANCEL switch

To turn off cruise control, push the ON•OFF switch

. Both the CRUISE indicator light

and SET indicator light in the instrument panel will extinguish.

For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.

USB (Universal Serial Bus) CONNECTION PORT/AUX JACK

and iPOD

INTERFACE

The USB port/Aux jack

is located beneath the

climate controls.

When a compatible USB memory device, iPod

auxiliary device is plugged into the USB port/Aux
jack, compatible audio files stored on the device can
be played through the vehicle’s audio system.

For more information, refer to the “Center display, heater, air conditioner, audio, phone and voice recognition systems
(section 4)” of your Owner’s Manual.

Then press and hold the desired station select button (1-6) until a beep is heard and the

sound is briefly muted. The channel indicator will appear on the display and the sound will
resume. Programing is now complete.

To retrieve a previously set station, select the radio band where the preset was stored

then press the corresponding station select button (1-6).

For more information, refer to the “Center display, heater, air conditioner, audio, phone and voice recognition systems
(section 4)” of your Owner’s Manual.

1766904_14d_Rogue_QRG_062514.indd 17

6/25/14 3:29 PM