NISSAN 2011 Quest - Owner's Manual - Manual (Page 216)

Black plate (210,1)
Model "E52-D" EDITED: 2010/ 10/ 25
Temperature control:
Push the temperature control buttons (“ ”
and “ ”) to set the desired temperature.
Air recirculation:
Push the air recirculation “ ” button to
recirculate interior air inside the vehicle. The
indicator light on the air recirculation “
”
button will illuminate.
The air recirculation mode cannot be activated
when the air conditioner is in the front defrosting
mode.
Outside air circulation:
Push the outside air circulation “ ” button to
draw outside air into the passenger compart-
ment. The indicator light on the outside air
circulation “
” button will turn on.
Heater operation
Heating:
This mode is used to direct heated air to the foot
outlets.
1. Push the outside air circulation “ ”
button to switch to the outside air circulation
mode. (The indicator light turns on.)
2. Push the air flow control button to change to
the mode.
3. Push the fan speed control buttons to set
the desired fan speed.
4. Push the temperature control buttons to set
the desired temperature between the middle
and the hot position.
Ventilation:
This mode directs outside air to the side and
center ventilators.
1. Push the outside air circulation “ ”
button to switch to the outside air circulation
mode. (The indicator light turns on.)
2. Push the air flow control button to change to
the mode.
3. Push the fan speed control buttons to
set the desired position.
Bi-level heating:
This mode directs cool air from the side and
center vents and warm air from the foot outlets.
When the temperature is set to the maximum hot
or cool position, the air between the ventilators
and the foot outlets is the same temperature.
1. Push the outside air circulation “ ”
button to switch to the outside air circulation
mode. (The indicator light turns on.)
2. Push the air flow control button to change to
the mode.
3. Push the fan speed control buttons to set
the desired fan speed.
4. Push the temperature control buttons to set
the desired temperature.
Heating and defogging:
This mode heats the interior and defogs the
windows.
1. Push the air flow control button to change to
the mode.
2. Push the fan speed control buttons to
set the desired fan speed.
3. Push the temperature control buttons to set
the desired temperature.
When the mode is selected, the air
conditioner will automatically turn on. This will
dehumidify the air and help to defog the
windows. The A/C indicator light will illuminate
when the air conditioner automatically turns on.
The air conditioner and A/C indicator light will
remain on in all flow control modes until the A/C
button is pressed.
Air conditioner operation
The air conditioner system should be operated
for approximately 10 minutes at least once a
month. This helps prevent damage to the air
conditioner system due to the lack of lubrication.
4-32 Monitor, heater, air conditioner, audio, phone and voice recognition systems