First drive features, Rear seat adjustments (hardtop models) – NISSAN 2012 Murano - Quick Reference Guide User Manual
Page 10
first drive features
8
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
POWER SEATS (if so equipped)
To slide the seat forward or backward, push the
control switch
01
forward or backward.
To recline the seatback, push the switch
02
forward or backward.
SEAT LIFTER (if so equipped for driver’s seat)
To adjust the angle of the front seat cushion or height
of the seat, push the front or rear end of the switch
01
up or down.
LUMBAR SUPPORT (if so equipped for driver’s seat)
To adjust the seat lumbar support, push the front or back end of the switch
03
.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)” of your
Owner’s Manual.
01
02
03
rear SeaT aDJuSTMeNTS (Hardtop models)
FOLDING DOWN THE REAR SEAT
To fold the seats flat, release the connector tongue
of the rear center seat belt from the buckle, then
store the connector and seat belt tongues in the
retractor base on the ceiling
01
.
Fold the seatback forward using either the pull
strap
02
located on the outside edge of the rear
seat or the release lever
03
in the cargo area.
To raise the seatback manually, lift up each seatback
and push it to the upright position until it is latched.
To raise the seatback automatically (if so equipped),
push and hold the power seatback switch located
in the cargo area
04
or the corresponding seat
switch on the lower side of the instrument panel
05
.
– A beep sounds once and the seatback begins to
move automatically.
– A beep sounds twice when the seatback is fully
returned to the upright seating position.
04
02
01
03
05