NISSAN 2010 Maxima - Owner's Manual - Manual (Page 253)

iPod
ா* PLAYER OPERATION
WITHOUT NAVIGATION SYSTEM (if
so equipped)
Connecting iPod
ா
To connect an iPod ா to the vehicle so that the
iPod
ா can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console. Open the protec-
tive cover
᭺
1 on the USB jack in the center
console. Then connect the iPod
ா-specific end of
the cable to the iPod ா and the USB end of the
cable to the USB jack on the vehicle. If your iPod ா
supports charging via a USB connection, its bat-
tery will be charged while connected to the ve-
hicle with the ignition switch in the ACC or ON
position.
While connected to the vehicle, the iPod
ா can
only be operated by the vehicle audio controls.
To disconnect the iPod
ா from the vehicle, remove
the USB end of the cable from the USB jack on
the vehicle, then remove the cable from the
iPod
ா.
* iPod
ா is a trademark of Apple Inc., registered in
the U.S. and other countries.
Compatibility
The following models are compatible:
● iPodா Classic - 1st through 6th generation
● iPodா Mini - 1st and 2nd generation
● iPodா Nano - 1st through 3rd generation
● iPodா Touch - 1st generation
● iPhoneா - 1st generation
Make sure that your iPod ா firmware is updated to
the version indicated above.
Audio main operation
Place the ignition switch in the ACC or ON
position. Press the AUX button repeatedly to
switch to the iPod
ா mode.
If the system has been turned off while the iPod
ா
was playing, pressing the VOL/ON·OFF control
knob will start the iPod
ா.
AUX button:
When the AUX button is pressed with the system
off and the iPod
ா connected, the system will turn
on. If another audio source is playing and the
iPod
ா is connected, press the AUX button re-
peatedly until the center display changes to the
iPod
ா mode.
WHA1366 LHA1395
4-92 Monitor, climate, audio, phone and voice recognition systems