NISSAN 2015 JUKE - Quick Reference Guide - Manual (Page 14)

To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi. 12
FIRST DRIVE FEATURES
WINDSHIELD WIPER AND WASHER SWITCH
Move the lever to one of the following positions to operate the windshield wipers:
1
Mist (MIST) - One sweep operation of the
front wipers.
2
Intermittent (INT) - Wipers operate
intermittently. The intermittent speed can be
adjusted by rotating the control ring
3 to
increase or decrease wiper speed.
4
Low (LO) - Front wipers operate at a
continuous low-speed.
5
High (HI) - Front wipers operate at a
continuous high-speed.
6
Pull the lever toward you to activate the
front washer. The front wipers will operate
several times.
REAR WINDSHIELD WIPER AND WASHER
7
Intermittent (INT) - Rear wiper operates
intermittently.
8
Low (ON) - Rear wiper operates at a
continuous low-speed.
9
Push the lever forward to activate the
rear washer. The rear wiper will operate
several times.
WIPER BLADE REPLACEMENT PROCEDURE
The windshield wipers must be in the service position in order to replace the wiper blades.
To move the wiper blades to the service position, follow this procedure:
When the ignition switch is in the ON position or within 60 seconds of placing the
ignition switch to the OFF position, lift the windshield wiper and washer lever up to the
Mist
position
1
two times in less than 0.5 seconds. The windshield wipers will
move to the service position automatically, and the wiper blades can now be replaced.
To move the wiper blades back to the original position:
Lift the windshield wiper and washer lever
up or lower the lever down to operate at any
wiper speed.
For more information, refer to the “Instruments and controls (section
2)” and the “Maintenance and do-it-yourself (section 8)” of your
Owner’s Manual.
6 9
1
2
4
5
MIST
OFF
INT
LO
HI
3
INT
ON
7
8
1705381_15a_Juke_QRG_091814.indd 12 9/18/14 4:46 PM