NISSAN 2013 JUKE - Owner's Manual - Manual (Page 200)

Black plate (198,1)
[ Edit: 2012/ 6/ 29 Model: F15-D ]
4-54 Heater, air conditioner, audio and phone systems
GETTING STARTED
The following procedures will help you get
started using the Bluetooth
® Hands-Free Phone
System with NISSAN Voice Recognition. For
additional command options, refer to “List of
voice commands” (P.4-55).
Choosing a language
You can interact with the Bluetooth ® Hands-
Free Phone System using English, Spanish or
French.
To change the language, perform the following.
1. Push and hold the button for more than
5 seconds.
2. The system announces: “Push the PHONE
SEND ( ) button for the hands-free
phone system to enter the speaker adapta-
tion mode or push the PHONE END (
)
button to select a different language.”
3. Push the button.
For information on speaker adaptation, see
“Speaker Adaptation (SA) mode” (P.4-59).
4. The system announces the current language
and gives you the option to change the
language to Spanish (in Spanish) or French
(in French). To select the current language,
press the
button. To select a different
language, tilt the tuning switch ( or )
up or down.
NOTE:
You must press the
button within 5
seconds to change the language.
5. If you decide not to change the language, do
not push either button. After 5 seconds, the
VR session will end, and the language will
not be changed.
Connecting procedure
NOTE:
The connecting procedure must be per-
formed when the vehicle is stationary. If
the vehicle starts moving during the pro-
cedure, the procedure will be cancelled.
1. Push the button on the steering wheel.
The system announces the available com-
mands.
2. Say: “Connect Phone” *
A . The system
acknowledges the command and an-
nounces the next set of available commands.
3. Say: “Add phone” *
B . The system acknowl-
edges the command and asks you to initiate
pairing from the phone handset
*
C .
The connecting procedure of the cellular
phone varies according to each cellular
phone. See the cellular phone Owner’s
Manual for details. You can also visit www.
nissanusa.com/bluetooth for instructions on
connecting NISSAN recommended cellular
phones.
When prompted for a Passkey code, enter
“1234” from the handset. The Passkey code
“1234” has been assigned by NISSAN and
cannot be changed.
4. The system asks you to say a name for the
phone *
D .
If the name is too long or too short, the
system tells you, then prompts you for a
name again.
Also, if more than one phone is connected
and the name sounds too much like a name
already used, the system tells you, then
prompts you for a name again.
Condition: