NISSAN 2012 GT R - Service & Maintenance Guide - Manual (Page 9)

GT-R Performance Optimization Services
In addition to the regular maintenance recommended by NISSAN, the GT-R requires the following Inspections;
Measurement and adjustment of wheel alignment
if needed (unladen with fuel and lubricants full,
including tire pressure adjustment) Note 1
● Note 1: This vehicle is equipped with a high performance suspension. As the suspension components
Љbreak-inЉ, the vehicle’s wheel alignment needs to be measured and adjusted by a GT-R certified dealer at the
recommended intervals.
Engine settings (balancing of air flow for left and right banks) Note 2
● Note 2: Each cylinder bank of this engine operates independently due to the vehicle’s twin turbocharger
design. Each side of the engine must operate at the same level of performance. The air flow of each bank must
be checked and adjusted as necessary by a GT-R certified NISSAN dealer.
Increase tightening of the drive shaft and center nut on hub Note 3
● Note 3: During the first GT-R special inspection (after driving 1,000 miles), the front and rear wheel hub lock
nuts (each one on the left and right sides) must be tightened to the specified tightening specification. The
wheel lock nuts should be properly tightened every time the inspection is performed.
Transmission settings Note 4
● Note 4: The design of the clutch and transmission requires inspection and adjustment of the clutch and shift
forks by a GT-R certified NISSAN dealer at the recommended intervals. Depending on driving conditions, more
frequent adjustments may be necessary to help maximize vehicle performance.
NISSAN MAINTENANCE
7