Programming homelink – NISSAN 2013 Altima Coupe - Owner's Manual User Manual
Page 120

WARNING
● Do not use the HomeLinkா Universal
Transceiver
with
any
garage
door
opener that lacks safety stop and re-
verse features as required by federal
safety standards. (These standards be-
came
effective
for
opener
models
manufactured after April 1, 1982). A ga-
rage door opener which cannot detect
an object in the path of a closing garage
door and then automatically stop and
reverse, does not meet current federal
safety standards. Using a garage door
opener
without
these
features
in-
creases the risk of serious injury or
death.
● During the programming procedure
your garage door or security gate will
open and close (if the transmitter is
within range). Make sure that people or
objects are clear of the garage door,
gate, etc. that you are programming.
● Your vehicle’s engine should be turned
off while programming the HomeLink
ா
Universal Transceiver. Do not breathe
exhaust gases; they contain colorless
and odorless carbon monoxide. Carbon
monoxide is dangerous. It can cause
unconsciousness or death.
PROGRAMMING HOMELINK
ா
If you have any questions or are having difficulty
programming your HomeLink
ா buttons, refer to
the HomeLink
ா web site at: www.homelink.com
or call 1-800-355-3515.
NOTE:
It is also recommended that a new battery
be placed in the hand-held transmitter of
the
device
being
programmed
to
HomeLink
ா for quicker programming and
accurate
transmission
of
the
radio-
frequency.
1. Position the end of your hand-held transmit-
ter 1–3 inches (5–14 cm) away from the
HomeLink
ா surface, keeping the HomeLinkா
indicator light
᭺
1
in view.
2. Using both hands, simultaneously press and
hold the desired HomeLink
ா button and
handheld transmitter button. DO NOT re-
lease until the HomeLink
ா indicator light
᭺
1
flashes slowly and then rapidly. When the
indicator light flashes rapidly, both buttons
may be released. (The rapid flashing indi-
cates successful programming.)
NOTE:
Some devices may require you to replace
Step 2 with the cycling procedure noted in
the “Programing HomeLink
ா for Canadian
customers and gate openers” section.
LIC2365
Instruments and controls
2-49