NISSAN 2012 370Z Roadster - Owner's Manual - Manual (Page 408)

9-14 Technical and consumer information
STI0618
EXCEPT FOR NISMO MODELS
Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag.
. License plate bracket
. J-nut 6 2
. Screw 6 2
. Screw grommet 6 2
1. Park the vehicle on flat, level ground. Locate
the two dents
*
A on the front bumper.
Carefully drill two pilot holes using a 0.39 in
(10 mm) drill bit. (Be sure that the drill
only goes through the bumper fascia.)
2. Insert grommets into the hole on the bumper
fascia.
3. Insert a flat-blade screwdriver into the
grommet hole to add 90
8 turn onto the part
*
B .
4. Make sure the side end surface of the
license plate bracket is aligned with the
bumper
*
C .
INSTALLING FRONT LICENSE PLATE