FORD 1998 Expedition - Manual (Page 191)

1. Remove the four screws that
secure the high-mount brakelamp
lens.
2. Carefully remove the lens.
3. Each of the three bulbs may be
removed with a
1 ⁄
4
turn
counterclockwise and a careful
pull.
4. Replace the bulbs as needed and
replace the high-mount brakelamp
lens.
Replacing tail lamp/backup
lamp bulbs
The tail lamp/backup lamp
assemblies are located in the same
portion of the vehicle rear, one just
below the other. Follow the same
steps to replace either bulb:
1. Open the liftgate to expose the
lamp assemblies.
2. Remove the two screws at the
top of the lens.
3. Carefully pop the lens off and to
the right (it may be necessary to
use a screwdriver to remove the
lens).
4. Twist the connector 1 ⁄
4
turn
counterclockwise and pull it out
for replacement.
5. Pull the bulb straight out of the
recess and replace it.
6. Replace the lens and secure the
two screws.
Maintenance and care
191