beautypg.com

Maintenance and specifications – FORD 2002 Thunderbird v.1 User Manual

Page 220

background image

BRAKE FLUID

Checking and adding brake fluid

Brake fluid should be checked and
refilled as needed. Refer to the
scheduled maintenance guide for
the service interval schedules.

1. Clean the reservoir cap before
removal to prevent dirt or water
from entering the reservoir.

2. Visually inspect the fluid level.

3. If necessary, add brake fluid from
a clean un-opened container until
the level reaches MAX. Do not fill
above this line.

4. Use only brake fluids certified to
meet Ford specification ESA-M6C25–A. Refer to Lubricant
specifications
in this chapter. DOT 3 fluid is recommended. However, if
DOT 3 is not available, DOT 4 fluid can be used.

Brake fluid is toxic. If brake fluid contacts the eyes, flush eyes
with running water for 15 minutes. Seek medical attention if

irritation persists. If taken internally, drink water and induce vomiting.
Seek medical attention immediately.

If you use DOT 5 or any other brake fluid that is not DOT 3 or
DOT 4, you will cause permanent damage to your brakes.

Do not let the fluid level in the reservoir for the master cylinder
fall below the MIN mark. If master cylinder runs dry, this may

cause the brakes to fail.

MAX

MIN

Maintenance and specifications

220