FORD 2002 Explorer Sport Trac v.2 - Manual (Page 64)

To reprogram the remote entry
transmitters:
1. Put the key in the ignition.
2. Turn the key from the 2 (LOCK) position to 3 (OFF).
3. Cycle, eight times, rapidly (within 10 seconds) between the 3 (OFF)
position and 4 (ON). Note: The eighth turn must end in the 4 (ON)
position.
4. The doors will lock than unlock to confirm that the programming
mode has been activated.
5. Within 20 seconds press any button on the remote entry transmitter.
Note: If more than 20 seconds have passed you will need to start the
procedure over again.
6. The doors will lock than unlock to confirm that this remote entry
transmitter has been programmed.
7. Repeat the previous step to program each additional remote entry
transmitter.
8. Turn the ignition to the 3 (OFF) position after you have finished
programming all of the remote entry transmitters.
9. The doors will lock, then unlock, to confirm that the programming has
been completed.
3
1
2
5
4
Locks and Security
64