FORD 2003 F-150 v.3 - Manual (Page 86)

Anti-scan feature
If the wrong code has been entered 36 times, the keypad will go into an
anti-scan mode. This mode disables the keypad for one minute and the
keypad lamp will flash during this time.
The anti-scan feature will turn off after:
• one minute of keypad inactivity.
• pressing the UNLOCK
control on the remote entry transmitter.
• the ignition is turned to the ON position.
Unlocking and locking the doors using keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate after pressing the first control on
the keypad.
To unlock all doors, press the 3
• 4 control within five seconds.
To lock all doors, press the 7
• 8 and the 9 • 0 at the same time. You
do not need to enter the keypad code first. Note: The interior lamps
will turn off.
Activating/deactivating autolock with the keyless entry system
Before following the activation or deactivation procedures, make sure
that the anti-theft system (if equipped) is not armed, ignition is off, and
all vehicle doors and liftgate window are closed.
1. Turn the ignition to the OFF position
2. Close all doors
3. Enter the 5-digit entry code
4. Press the and hold the 7/8. While holding the 7/8 press the 3/4
5. Release the 3/4
6. Release the 7/8
The horn will chirp once if autolock was deactivated or twice (one short
and one long chirp) if autolock was activated.
To re-activate autolock, repeat steps 1-6.
SECURILOCK
ி PASSIVE ANTI-THEFT SYSTEM
SecuriLock
௢ passive anti-theft system is an engine immobilization
system. This system is designed to prevent the engine from being started
Locks and Security
86