Driver controls – FORD 2003 Crown Victoria v.4 User Manual

Page 68

4. Repeatedly press and release the
RESET button to scroll through the
zones 1–15 until the desired zone is
displayed.

5. Press the MODE button to save
the new zone setting and return to
the compass normal mode.

Note: The compass exits the zone
setting mode and returns to its
previous setting after one minute of
no activity.

Note: If power is interrupted during the zone setting process, the
compass resets to the same zone it was set to before the zone change
process was started.

Calibration mode

To calibrate the compass:

1. Press and release the MODE
button until the compass directional
heading is displayed.

2. Hold down the MODE button for
10 seconds to enter the calibration
mode. The display will read PRESS
RESET TO DECAL.

3. Release the MODE button.

4. Press the RESET button to
de-calibrate the compass. The
display will read CIRCLE SLOWLY
TO CALIBRATE for a few seconds
and then display a direction with
CAL displayed on the right side.

5. Slowly drive the vehicle in a
circle (less than 5 km/h [3 mph]).
This will take up to three circles to complete calibration.

7 8 9 1011

2003 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA English (fus)

Driver Controls