FORD 2004 Freestar v.2 - Manual

The following information is specifically for the Freestar cargo
van only; it is in addition to the existing information found on
pages 200, 201, 207 and 208.
Location of the spare tire and tools
Item Location
Jack extension tool Attached to the jack kit.
Removing the spare tire
1. Lift flap in mat to expose
hex nut. Insert extension tool
through access hole and
engage hex nut. Place lug
wrench onto end of extension
tool.
Stowing the full-size tire
1. Remove the perforated section of the vinyl mat in the center
floor area in order to install the wing screw.
2. Using the tether cable kit located with the jack, pass the cable
retainer through the center of the wheel.
3. Lay the tire flat and secure the cable with wing screw by
installing it on the wing screw retainer in the floor and turning
the wing screw clockwise. You will hear an audible click when
the tire is properly secured.
Stowing the spare tire
3. Raise the tire by turning the jack extension tool clockwise
with the lug nut wrench until the hex nut ratchets.