FORD 2004 Freestar v.1 - Manual (Page 72)

U.S. federal safety standards (this includes any garage door opener
model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLink
௡ at: www.homelink.com or 1–800–355–3515.
Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLink
௡ equipped vehicle
purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelink
௡ buttons be erased for security purposes, refer to
Programming in this section.
Programming
Do not program HomeLink
௡ with the vehicle parked in the garage.
Note: Your vehicle may require the ignition switch to be turned to the
ACC position for programming and/or operation of the HomeLink
௡. It is
also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLink
௡ for quicker
training and accurate transmission of the radio-frequency signal.
1. Press and hold the two outside
buttons releasing only when the red
light begins to flash after 20
seconds. Do not repeat step one to
program additional hand-held
transmitters to the remaining two
HomeLink
௡ buttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink
௡.
2. Position the end of your
hand-held transmitter 2–8 cm (1–3 inches) away from the HomeLink
௡
button you wish to program (located on your visor) while keeping the
red light in view.
3. Simultaneously press and hold
both the HomeLink
௡ and hand-held
transmitter button. Do not release
the buttons until step 4 has been
completed.
Some entry gates and garage door
openers may require you to replace
step 3 with procedures noted in the
“Gate Operator and Canadian Programming” section for Canadian
residents.
2004 Windstar (win)
Owners Guide (post-2002-fmt)
USA English (fus)
Driver Controls
72