beautypg.com

Driver controls – FORD 2004 F-150 v.5 User Manual

Page 70

background image

• Continue to press and hold the HomeLink௡ button (note step 3 in the

“Programming” section) while you press and release — every two
seconds
(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink

௡. The indicator light will

flash slowly and then rapidly after HomeLink

௡ accepts the radio

frequency signal.

• Proceed with step 4 in the “Programming” section.

Operating the HomeLink

Wireless Control System

To operate, simply press and release
the appropriate HomeLink

௡ button.

Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLink

௡ at www.homelink.com or

1–800–355–3515.

Erasing HomeLink

buttons

To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer

HomeLink

௡ buttons until the

indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.

HomeLink

௡ is now in the train (or

learning) mode and can be programmed at any time beginning with step
2 in the “Programming” section.

Reprogramming a single HomeLink

button

To program a device to HomeLink

௡ using a HomeLink௡ button previously

trained, follow these steps:

1. Press and hold the desired HomeLink

௡ button. Do NOT release the

button.

2004 F150 (f12)
Owners Guide (post-2002-fmt)
USA English
(fus)

Driver Controls

70