FORD 2005 F-550 v.3 - Manual (Page 285)

Fluid
Ford Part
Name
Application Capacity
Automatic
transmission
fluid
3
Motorcraft
MERCON
௡ SP
ATF
TorqShift
(5–speed) 17.5 quarts
(16.6L)
5 (includes
remote filter
element change)
Windshield
washer fluid Motorcraft
Premium
Windshield
Washer
Concentrate All 4.25 quarts
(4.0L)
1 Add 8 oz. (236 ml) of Additive Friction Modifier XL-3 or equivalent
meeting Ford Specification EST-M2C118–A for complete refill of limited
slip axles. Ford design rear axles contain a synthetic lubricant that does
not require changing unless the axle has been submerged in water. Dana
rear axles also contain a synthetic lubricant but do require a change.
Refer to your Scheduled Maintenance Guide for change intervals on
Dana rear axles.
2 Add the coolant type originally equipped in your vehicle.
3 Ensure the correct automatic transmission fluid is used. Transmission
fluid requirements are indicated on the end of the dipstick. Check the
container to verify the fluid being added is of the correct type. Refer to
your Scheduled Maintenance Guide to determine the correct service
interval.
MERCON
௡, MERCON௡ V and MERCON௡ SP are not
interchangeable. DO NOT mix MERCON
௡, MERCON௡ V and
MERCON
௡ SP. Use of dual usage fluids in an automatic
transmission application requiring MERCON
௡ SP may cause
transmission damage. Use of a transmission fluid other than the
recommended fluid may cause transmission damage.
4 Service refill capacity is determined by filling the transmission to the
bottom of the filler hole with the vehicle on a level surface. The 6–speed
manual transmission is equipped with an in-tank cooler. Verify the fluid
level after operating vehicle to assure correct fluid level.
5 Indicates only approximate dry-fill capacity. Some applications may vary
based on cooler size and if equipped with an in-tank cooler. The amount
of transmission fluid and fluid level should be set by the indication on
the dipstick’s normal operating range.
2005 F250/350/450/550 (f23)
Owners Guide (post-2002-fmt)
USA_English (fus)
Maintenance and Specifications
285