FORD 2005 Crown Victoria v.3 - Manual (Page 89)

Autolock (if equipped)
This feature automatically locks all vehicle doors when:
• all doors are closed,
• the ignition is in the 3 (ON) position,
• the brake pedal is depressed,
• you shift into any gear.
Relock
The autolock feature repeats when:
• the ignition is in the 3 (ON) position,
• a door is opened and closed,
• the transmission is placed in R (Reverse) or any drive gear, and then
• the brake pedal is depressed and then released.
Deactivating/activating the autolock feature
Before following the procedure, make sure that the ignition is in the 3
(OFF) position and all vehicle doors are closed.
Automatic door locks can also be turned on/off through the following
procedure:
You must complete Steps 1-7 within 30 seconds or the procedure will
have to be repeated. If the procedure needs to be repeated, you must
wait at least 30 seconds.
1. Turn the ignition to the 3 (ON) position.
2. Press the power door unlock control on the door panel three times.
3. Turn the ignition from the 3 (ON) to the 1 (OFF/LOCK) position.
4. Press the power door unlock control three times.
5. Turn the ignition back to the 3 (ON) position.
6. The door locks will lock/unlock to confirm programming mode is
entered/active.
7. With the ignition still in the 3 (ON) position, press the unlock control
once. After a five to ten second delay, the door will lock/unlock to
confirm successful programming.
8. After having waited the necessary time for the programming to
confirm, turn the ignition to the 1 (OFF/LOCK) position.
Once disabled, the autolock feature can be enabled by repeating the
procedure in Steps 1–8.
2005 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
89