FORD 2006 Escape Hybrid v.2 - Manual (Page 300)

Changing the high voltage battery air filter element
1. Remove access panel located in
the rear cargo area on the driver’s
side trim panel to expose the filter
cover.
2. Push the tabs (located on each
side of filter cover) while pulling
gently to remove filter cover.
3. Install new filter and filter cover (note arrows indicating top side).
4. Re-install the access panel into the trim panel.
MOTORCRAFT PART NUMBERS
Component 2.3L I4 engine
Oil filter FL-2017-B 1
PCV valve 2
Spark plugs 3
Engine air filter element FA-1772 4
Rear A/C (high voltage battery cooling) air filter element FP-51
Fuel filter FG-800-A
Low voltage (underhood) battery BXT-96R
1 When changing oil filter you must also replace the filter cap O-ring. The
oil filter drain plug O-ring must also be replaced whenever the oil filter
drain plug is removed. Re-use of the O-rings may cause engine oil leakage
and may result in severe engine damage. The customer warranty may be
voided for any damage to the engine if the O-rings are not replaced.
REVIEW COPY ——
2006 Escape Hybrid (ehv), Owners Guide (post-2002-fmt) (own2002), Market: USA (fus)
Maintenance and Specifications
300