FORD 2007 F-150 v.3 - Manual (Page 114)

1. Press and hold the two outside
buttons releasing only when the
indicator light begins to flash after
20 seconds. Do not repeat Step 1
to program additional hand-held
transmitters to the remaining two
HomeLink
௡ buttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink
௡.
2. Position the end of your
hand-held transmitter 1–3 inches (2–8 cm) away from the HomeLink
௡
button you wish to program (located on your visor) while keeping the
indicator light in view.
3. Simultaneously press and hold
both the chosen HomeLink
௡ and
hand-held transmitter buttons until
the HomeLink
௡ indicator light
changes from a slow to a rapidly
blinking light. Now you may release
both the HomeLink
௡ and hand-held
transmitter buttons.
Note: Some entry gates and garage door openers may require you to
replace Step 3 with procedures noted in the “Gate Operator and
Canadian Programming” in this section for Canadian residents.
4. Firmly press, hold for five seconds and release the programmed
HomeLink
௡ button up to two separate times to activate the door. If the
door does not activate, press and hold the just-trained HomeLink
௡
button and observe the indicator light.
• If the indicator light stays on constantly, programming is complete
and your device should activate when the HomeLink
௡ button is pressed
and released.
• If the indicator light blinks rapidly for two seconds and then turns
to a constant light continue with “Programming” Steps 5 through
7 to complete programming of a rolling code equipped device (most
commonly a garage door opener).
5. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).
2007 F-150 (f12)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
114