FORD 2007 Expedition v.1 - Manual (Page 114)

2. Press the 1
• 2 control within five seconds of Step 1.
3. Enter your personal 5–digit code.
Enter each digit within five seconds
of previous one.
4. After the code is entered, the
locks will cycle, confirming that the
new code has been set.
Do not set a code that includes five of the same number or presents
them in sequential order. Thieves can easily figure out these types of
codes.
Your personal code does not replace the permanent code that your
authorized dealer gave you. You can use either code to unlock your
vehicle. If a second personal code is entered, the module will erase the
first personal code in favor of the new code.
If you wish to erase your personal code, use the following instructions:
1. Enter the factory set code.
2. Press the 1
• 2 control and release.
The system will now only respond to the factory set code.
Unlocking and locking the doors, liftgate and liftgate window using
keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate.
To unlock all doors and liftgate, press the 3
• 4 control within five
seconds.
To open the liftgate window, press the 5
• 6 control within five seconds.
To lock all doors, liftgate and liftgate window, press the 7
• 8 and
the 9
• 0 at the same time. Note: The driver’s door must be closed. You
do not need to enter the keypad code first.
SECURILOCK
ி PASSIVE ANTI-THEFT SYSTEM
SecuriLock
௢ passive anti-theft system is an engine immobilization
system. This system is designed to help prevent the engine from being
started unless a coded key programmed to your vehicle is used.
The SecuriLock
௢ passive anti-theft system is not compatible with
non-Ford aftermarket remote start systems. Use of these systems may
result in vehicle starting problems and a loss of security protection.
2007 Expedition (exd)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
114