FORD 2007 Edge v.1 - Manual (Page 116)

Two stage unlocking may be disabled or re-enabled by simultaneously
pressing the
and controls on the IKT for four seconds (disabling
two stage unlock allows all vehicle doors to unlock simultaneously). The
turn lamps will flash twice to indicate that two-stage unlock was enabled
or disabled.
Locking the doors
1. Press and release to lock all the doors. The turn lamps will flash.
2. Press and release again within five seconds to confirm that all the
doors are closed. Note: The doors will lock again, the horn will chirp and
the turn lamps will flash once if all the doors and liftgate are closed.
Note: If any door or the liftgate is not closed, the horn will chirp twice
and the lamps will not flash.
Car finder
Press twice within 3 seconds. The horn will chirp and the turn lamps
will flash. It is recommended that this method be used to locate your
vehicle, rather than using the panic alarm.
Sounding a panic alarm
Press and hold for 1.5 seconds to activate the alarm. The horn will
sound and the turn lamps will flash for a maximum of 3 minutes. The
alarm can be deactivated with a short press and release of
, by
turning the ignition to RUN, or by allowing the alarm to time out after 3
minutes.
Note: The panic alarm will only operate when the ignition is in the 1
(LOCK) position.
Memory seat feature (if equipped)
The Integrated Keyhead Transmitter allows you to recall the memory
seat/mirror feature.
Press to automatically move the seat/mirror to the desired memory
position. Note: The seat will not travel to its final position if the key is
not in the ignition and the easy entry feature is enabled.
Activating the memory feature
To activate this feature:
1. Position the seat and mirrors to the desired positions.
2007 Edge (edg)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
116