FORD 2007 Crown Victoria v.1 - Manual (Page 54)

Programming
Do not program the HomeLink
௡ with the vehicle parked in the
garage.
Note: Some vehicles may require the ignition switch to be turned to the
second (or “ACC”) position for programming and/or operation of the
HomeLink
௡. It is also recommended that a new battery be placed in the
hand-held transmitter of the device being programmed to HomeLink
௡ for
quicker training and accurate transmission of the radio-frequency signal.
1. Press and hold the two outside
buttons. The message CLEARING
CHANNELS will appear on the
HomeLink
௡ display.
• After about 20 seconds, the
message CHANNELS CLEARED
will appear.
Do not repeat step one to program additional hand-held transmitters to
the remaining two HomeLink
௡ buttons. This will erase previously
programmed hand-held transmitter signals into HomeLink
௡.
2. Position the end of your hand-held transmitter 1–3 inches (2–8 cm)
away from the HomeLink
௡ button you wish to program (located on your
overhead console) while keeping the display in view.
2007 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
54