beautypg.com

Switching from two step to one step door unlocking, Locking the doors/liftgate, Opening the liftgate window – FORD 2008 Explorer v.1 User Manual

Page 153: Car finder, Sounding a panic alarm, Locks and security

background image

Switching from two step to one step door unlocking

Your vehicle comes with two step unlocking enabled. Unlocking can be
switched between two step and one step door unlocking by pressing and
holding both the

and

buttons simultaneously on the remote entry

transmitter for approximately 4 seconds. The parklamps will flash twice
to indicate that the vehicle has switched to one step unlocking. Repeat
the procedure to switch back to two-step unlocking.

Locking the doors/liftgate

1. Press

and release to lock all the doors and liftgate. The lamps will

flash. Note: If any door, the liftgate or the liftgate glass are not closed
properly, the lamps will not flash.

2. Press

and release again within three seconds to confirm that all the

doors are closed and locked. Note: The doors will lock again, the horn
will chirp and the lamps flash once.

Note: If any door, the liftgate or the liftgate glass are not closed
properly, the horn will make two quick chirps.

Opening the liftgate window

Press

to unlatch the liftgate window.

Car finder

Press

twice within three seconds. The horn will chirp and the turn

lamps will flash. It is recommended that this method be used to locate
your vehicle, rather than using the panic alarm.

Sounding a panic alarm

Press

to activate the alarm. The horn will sound and the parklamps

will flash for a maximum of 3 minutes. Press again or turn the ignition to
the 3 (ON) position to deactivate, or wait for the alarm to timeout in 3
minutes.

Note: The panic alarm will only operate when the ignition is in the 1
(OFF/LOCK) position .

2008 Explorer (exp)
Owners Guide (post-2002-fmt)
USA
(fus)

Locks and Security

153