FORD 2009 Taurus v.3 - Manual (Page 83)

Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
௡ to accept the signal
from the hand-held transmitter.
After completing Step 1 outlined in
the Programming section, replace
Step 2 with the following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
• Continue to press and hold the HomeLink௡ button (note Step 2 in the
Programming section) while you press and release — every two
seconds (“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
௡. The indicator light will
flash slowly and then rapidly after HomeLink
௡ accepts the radio
frequency signal.
• Proceed with Step 3 in the Programming section.
Operating the HomeLink ா Wireless Control System
To operate, simply press and release
the appropriate HomeLink
௡ button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the event that there are still
programming difficulties, contact HomeLink
௡ at www.homelink.com or
1–800–355–3515.
Driver Controls
83
2009 Taurus (500)
Owners Guide (own2002), 3rd Printing
USA (fus)