beautypg.com

Two step door unlocking, One step door unlocking, Switching from two step to one step door unlocking – FORD 2009 Explorer v.2 User Manual

Page 160: Locks and security

background image

The remote entry system allows you
to lock or unlock all vehicle doors
and liftgate, open the liftgate
window without a key and activate
the panic alarm.

The remote entry lock/unlock
feature operates in any ignition
position. The liftgate glass feature
operates as long as the vehicle’s
speed is less than 3 mph (5 km/h).
The panic feature operates with the
key in the off position.

If there is any potential remote keyless entry problem with your vehicle,
ensure ALL remote entry transmitters are brought to the authorized
dealer to aid in troubleshooting.

Two step door unlocking

1. Press

and release to unlock the driver’s door. Note: The interior

lamps will illuminate (refer to the Illuminated entry feature later in this
section) if the control on the overhead lamp is not set to the off
position and the perimeter alarm system (if equipped) will deactivate.

2. Press

and release again within three seconds to unlock the

passenger doors, the liftgate and liftgate glass.

The battery saver feature will turn off the interior lamps 30 minutes after
the ignition is turned to the off position.

One step door unlocking

If the one step door unlocking feature is activated, press

and release

once to unlock all of the doors, the liftgate and liftgate glass. Note: The
interior lamps will illuminate (refer to the Illuminated entry feature
later in this section). If the control on the overhead lamp is in the door
position, the perimeter alarm system (if equipped) will deactivate.

Switching from two step to one step door unlocking

Your vehicle comes with two step unlocking enabled. Unlocking can be
switched between two step and one step door unlocking by pressing and
holding both the

and

buttons simultaneously on the remote entry

transmitter for approximately four seconds. The parklamps will flash
twice to indicate that the vehicle has switched to one step unlocking.
Repeat the procedure to switch back to two-step unlocking.

2009 Explorer (exp)
Owners Guide, 2nd Printing
USA
(fus)

Locks and Security

160