FORD 2010 Taurus v.1 - Manual (Page 170)

Note: If you are using MyKey™, the Belt-Minder
௡ cannot be disabled.
Also, if the Belt-Minder
௡ has been previously disabled, it will be
re-enabled during the use of MyKey™. Refer to MyKey™ in the Locks
and Security chapter.
The driver and front passenger Belt-Minder
௡ features can be
deactivated/activated by performing the following procedure:
Before following the procedure, make sure that:
• The parking brake is set.
• The gearshift is in P (Park).
• The ignition is off.
• The driver and front passenger safety belts are unbuckled.
WARNING: While the design allows you to deactivate your
Belt-Minder
௡, this system is designed to improve your chances of
being safely belted and surviving an accident. We recommend you
leave the Belt-Minder
௡ system activated for yourself and others who
may use the vehicle. To reduce the risk of injury, do not
deactivate/activate the Belt-Minder
௡ feature while driving the vehicle.
1. Switch the ignition on. DO NOT START THE ENGINE.
2. Wait until the safety belt warning light turns off (approximately one
minute).
3. Wait 10 seconds after the safety belt warning light turns off.
• Step 4 must be completed within 20 seconds after the completion of
Step 3.
4. For the seating position being disabled buckle then unbuckle the
safety belt three times at a moderate speed, ending in the unbuckled
state.
• After Step 4, the safety belt warning light will be turned on for three
seconds.
5. Within approximately seven seconds of the light turning off, buckle
then unbuckle the safety belt.
• This will disable the Belt-Minder௡ feature for that seating position if it
is currently enabled. As confirmation, the safety belt warning light will
flash four times per second for three seconds.
Seating and Safety Restraints
170
2010 Taurus (500)
Owners Guide (own2002), 1st Printing
USA (fus)