beautypg.com

Turn signal control, Interior lamps, Map lamps – FORD 2010 Mustang v.2 User Manual

Page 64: Bulb replacement, Lamp assembly condensation, Lights

background image

5. Then use a 7mm Allen wrench or a Phillips screwdriver to adjust the
headlamp up or down. HORIZONTAL AIM IS NOT REQUIRED FOR THIS
VEHICLE AND IS NON-ADJUSTABLE.

6. Close the hood and turn off the lamps.

TURN SIGNAL CONTROL
• Push down to activate the left

turn signal.

• Push up to activate the right turn

signal.

The flash rate of the turn signal indicator will speed up considerably if
any of the turn signal lamps are out.

Note: For sequential rear turn signal lamps, an outage of the inner most
of the three compartments will result in this rapid flash rate.

INTERIOR LAMPS

Map lamps

Press the controls on either side of
the lamp to turn the light on.

BULB REPLACEMENT

Lamp assembly condensation

Exterior lamps are vented to accommodate normal changes in pressure.
Condensation can be a natural by-product of this design. When moist air
enters the lamp assembly through the vents, there is a possibility that
condensation can occur when the temperature is cold. When normal
condensation occurs, a thin film of mist can form on the interior of the

Lights

64

2010 05+ Mustang (197)
Owners Guide, 2nd Printing
USA
(fus)